https://www.braindisconnect.com/wiki/index.php?title=Dell_DRAC&feed=atom&action=historyDell DRAC - Revision history2024-03-28T23:38:23ZRevision history for this page on the wikiMediaWiki 1.39.1https://www.braindisconnect.com/wiki/index.php?title=Dell_DRAC&diff=11&oldid=prevJbutler: Created page with "Category:Servers Dell Remote Access Controller ==== DRAC Configuration ==== Press <Ctrl-E> for Remote Access Setup within 5 sec.. ==== Default IP Address ==== DRAC defau..."2015-03-02T14:29:02Z<p>Created page with "<a href="/wiki/index.php/Category:Servers" title="Category:Servers">Category:Servers</a> Dell Remote Access Controller ==== DRAC Configuration ==== Press <Ctrl-E> for Remote Access Setup within 5 sec.. ==== Default IP Address ==== DRAC defau..."</p>
<p><b>New page</b></p><div>[[Category:Servers]]<br />
Dell Remote Access Controller<br />
<br />
==== DRAC Configuration ====<br />
Press <Ctrl-E> for Remote Access Setup within 5 sec..<br />
<br />
==== Default IP Address ====<br />
DRAC defaults to 192.168.0.120<br />
<br />
==== Serial Output over SSH ====<br />
Taken from the Dell Advanced Configuration of the iDRAC6 Manual[http://support.dell.com/support/edocs/software/smdrac3/idrac/idrac10mono/en/ug/html/racugc5.htm].<br />
<br />
# Turn on or restart your system.<br />
# Press <F2> immediately after you see the following message: <br> <F2> = System Setup<br />
# Scroll down and select Serial Communication by pressing <Enter>.<br />
# Set the Serial Communication screen options as follows:<br> serial communication....On with serial redirection via com2<br>serial port address....Serial device1 = com1, serial device2 = com2<br>external serial connector....Serial device 1<br>failsafe baud rate....115200<br>remote terminal type....vt100/vt220<br>redirection after boot....Enabled<br>Then, exit and select Save Changes.<br />
# Press <Esc> to exit the System Setup program and complete the System Setup program configuration.<br />
<br />
==== Connecting to a DRAC enabled device via SSH ====<br />
SSH to the device via SSH.<br />
<br />
===== Enable Serial Console =====<br />
Run the following command to enable the serial console via ssh.<br />
racadm config -g cfgSerial -o cfgSerialSshEnable 1<br />
<br />
==== Useful Commands ====<br />
===== Console Connection =====<br />
connect com2<br />
<br />
===== One Time PXE Boot =====<br />
Setup the server for a boot once configuration. Once the server reboots the configuration is cleared.<br />
racadm config -g cfgServerInfo -o cfgServerBootOnce 1<br />
<br />
Setup the server to boot via PXE on next reboot.<br />
racadm config -g cfgServerInfo -o cfgServerFirstBootDevice PXE<br />
<br />
===== Reboot the Server =====<br />
The server can be power cycled to accomplish the reboot.<br />
racadm serveraction powercycle</div>Jbutler